Programmable buttons
The Programmable Buttons feature allows agencies to customize the device behavior
for Programmable Buttons 1 and 2.
Your Evidence admin can change the device behavior in the Admin settings page
under Programmable Buttons.
l
Activate Button 1 with a double-press.
l
Activate Button 2 with either a single press or double-press, depending on the
configuration.
For example, if Programmable Button 1 is configured to be Sleep, double-pressing it
will cause the camera to enter Sleep mode.
For a Respond+ agency, the default behavior of Programmable Button 1 will be Watch
Me and the default behavior of Programmable Button 2 will be No Function.
Optimized battery capacity
If this setting is enabled in the Admin section of Axon Evidence, the camera will only
charge to about 90% capacity and display FULL when finished charging instead of
100%. While this will reduce run-time, it will improve long-term battery health and
reduce degradation.
Agencies should analyze their battery needs during the first few weeks of deployment
and if users don’t require the full 100% of battery, enable this setting to improve long-
term battery health with only a minor reduction in run-time.
End recording confirmation
This feature prevents unintentional ending of recordings. If enabled, ending a
recording will require a secondary confirmation press of Select.
l
Always – Confirmation always required.
l
Auto – Confirmation only required if Event is pressed during a recording.
Axon Signal
The Body 4 camera is compatible with Axon Signal technology. Your administrator
must activate Axon Signal capability prior to use.
When it is active, Axon Signal technology can broadcast a signal that allows your
camera to transition from Ready to Recording mode automatically. When your camera
starts recording, you will see, hear, and feel all the normal start recording notifications.
Axon Enterprise, Inc. 12
Body 4 Camera User Guide
To Next Page
Loading...
Need help?
General
