Illuminate the camera display
In low-light situations, press any camera button to illuminate the camera display for
five seconds.
To change light settings, see Change light settings and Stealth mode starting on page
11.
Battery status
The battery capacity for your camera appears on the camera display as a percentage.
The Operation and Triad LEDs also reflect battery level; see Icons, LEDs, and sounds
on page 33.
Sleep mode
Sleep mode puts the camera in an idle state that disables recording and buffering.
While in this state, an automatic activation enabled at your agency will not initiate
camera recording.
Note
The ability to use Sleep mode is enabled by your agency Axon Evidence
administrator and may not be available at your agency.
Sleep mode is useful for situations where camera users may need momentary privacy.
You can enter Sleep mode from the buffering state in less than three seconds, as
opposed to turning the camera completely off. Similarly, the camera will exit Sleep
mode and enter a buffering or recording state in less than three seconds.
The device audit trail reflects when Sleep mode is entered and exited. While Sleep
mode can be used as an alternative to completely powering down the camera during
private situations, it should not be considered a replacement for powering the camera
off. Certain background processes are running while the camera is in Sleep mode and
the battery still depletes while in this mode, but at a slower rate.
Enter and exit sleep mode
To enter Sleep mode with Power Off Confirmation disabled:
1. Press the power button.
2. Press Select to enter sleep mode.
Axon Enterprise, Inc. 16
Body 4 Camera User Guide
To Next Page
Loading...
Need help?
General
