Baur DTA 100 C User Manual

DTA 100 C Device settings
822-129-8 41 / 90
8.7 Configure settings for user-defined measurements
With user-defined measurements, it is possible to set the electrode shapes and the distance
between the electrodes.
Prerequisite
The desired distance between electrodes has been set.
Further information: Chapter Setting an electrode gap (on page 28)
Procedure
Main menu > Device settings > User-defined measurement settings
1. In the main menu, select the menu item Device settings.
2. Select the menu item Next to confirm the selection.
3. In the Device settings menu, select the User-defined measurement settings menu
item and then Next.
A prompt to select an electrode shape appears on the display.
4. Choose an electrode shape by pressing the arrow keys.

Baur DTA 100 C Specifications

General

Brand	Baur
Model	DTA 100 C
Category	Test Equipment
Language	English