4-6
Confidential
2. IF YOU REPLACE THE LASER UNIT
<What to do after replacement>
• Entering adjusted value of laser unit
îš„ What you need to prepare
(1) One USB cable
(2) Create a temporary folder on the C drive of the computer (Windows
®
XP or higher).
(3) Service setting tool (BrUsbn.zip)
Copy this file into the temporary folder created on the C drive. Extract the copied file and
double-click "BrUsbsn.exe" to start it.
(4) Download utility (FILEDG32.EXE)
Copy this file into the temporary folder created on the C drive.
(5) Maintenance driver (MaintenanceDriver.zip)
When the maintenance driver is not installed, copy this file into the temporary folder
created on the C drive, and extract the copied file. Refer to "APPENDIX 3 INSTALLING
MAINTENANCE DRIVER" for the installation procedure.
2.1 Entering Adjusted Value of Laser Unit
(1) Enter maintenance mode.
(2) Connect the computer to the machine with the USB cable.
(3) Double-click the "BrUsbsn.exe" file that was copied to the temporary folder to start it.
(4) Click "Laser 11Model".
To Next Page
Loading...
Need help?
General