5-22
Confidential
1.3.13
Change USB No. return value / Adjust left-end print start position on second side when
duplex printing / Change ON/OFF setting for Deep Sleep function (function code: 45)
îš„ Change USB No. return value
<Function>
When the operating system (OS) installed on the computer is Windows Vista
®
, and the
machine is connected to this computer using USB2.0FULL, the OS may not be able to obtain
the USB device serial number depending on the computer and USB device. If the serial
number cannot be obtained, the number of devices increases each time the device is
connected to the computer. To avoid this problem, setting this function to "USBNo.=ON" can
fix the USB No. return value to "0".
The setting currently selected is marked "*" at the end of the display.
<Operation Procedure>
(1) Press the [4] and [5] buttons in this order in the initial state of maintenance mode.
"USBNo." is displayed on the LCD.
(2) Press the [OK] button. "USBNo.=ON" is displayed on the LCD.
(3) Press the [ ] or [ ] button to display "USBNo.=ON" when fixing the serial number
return value to "0" or "USBNo.=OFF" when not fixing it.
(4) Press the [OK] button. "Accepted" is displayed on the LCD, and the machine returns to
the initial state of maintenance mode.
(5) Turn OFF the power switch.
îš„ Adjust left-end print start position on second side when duplex printing
<Function>
In the event that the left-end print start position deviates on the second side when duplex
printing, use this function to adjust the position left and right.
The adjustable range is -100 to 750 (unit: 300 dpi). (Shifted to left when the value is negative)
<Operation Procedure>
(1) Press the [4] and [5] buttons in this order in the initial state of maintenance mode.
"USBNo.=ON" is displayed on the LCD.
(2) Press the [ ] or [ ] button to display "DX.XAdjust" on the LCD.
(3) Press the [OK] button. "DX.XAdjust=**" is displayed on the LCD.
(The value currently set is displayed for **.)
(4) To shift the writing start position to the left, press the [ ] button to decrease the value.
To shift the position to the right, press the [ ] button to increase the value.
(5) Press the [OK] button. "Accepted" is displayed on the LCD, and the machine returns to
the initial state of maintenance mode.
LCD Description
USBNo. = ON Returns the serial number of the machine. (Default)
USBNo. = OFF Returns "0".
Note:
• The setting is applied after the power switch is turned OFF and then ON again.
To Next Page
Loading...
Need help?
General