5-10
Confidential
Refer to the separate manual for details of worker switches.
<Operation Procedure>
(1) Press the [1] and [0] buttons in this order in the initial state of maintenance mode.
"WSW00" is displayed on the LCD.
(2) Enter the worker switch number that you want to change the setting.
The display shown below appears on the LCD.
(3) Press the [ ] or [ ] button to move the cursor to the desired selector, and change the
setting by pressing the [1] or [0] button.
(4) When changing the setting is completed, press the [OK] button. The new selector setting
value is stored in the EEPROM, and the LCD returns to the ready state for worker switch
number entry ([WSW00]).
(5) When worker switch setting is completed, press the [Stop/Exit] button to return the
machine to the initial state of maintenance mode.
WSW79 Function setting 27
WSW80 Copy speed adjustment
WSW81 Emulation function deletion
WSW82 AirPrint icon type setting
Note:
• To cancel operation and return to the initial state of maintenance mode, press the
[Stop/Exit] button.
• If there is no entry for one minute or longer on 2-digits firmware switch number
selection, the machine returns to the initial state of maintenance mode automatically.
WSW No. Function
WSWXX = 0 0 0 0 0 0 0 0
Selector No. 1 Selector No. 8
To Next Page
Loading...
Need help?
General