Chapter 6
6-38
USB, IEEE1394, network
2. L Printer Service Tool
Procedure
1) Start L Printer Service Tool.
2) Place the printer in the online mode.
3) Specify the firmware file(jdl) and then transfer it.
4) The data shown on the LCD on the operation panel changes and the firmware is updated automatically.
5) When firmware update is completed, the printer will start again.
File transfer route:
USB, IEEE1394, network (directly connected using a cross cable)
6.4 Service Tools
6.4.1 List of Tools
0012-6675
T-6-46
T-6-47
General-purpose tools Application
Long phillips scerewdriver Inserting and removing screw
Phillips scerewdriver Inserting and removing screw
Flat-head screwdriver Removing the E-ring
Needle-nose pliers Inserting and removing the spring parts
Hex key wrench Inserting and removing hexagonal screws
Flat brush Applying grease
Lint free paper Wiping off ink
Rubber gloves Preventing ink stains
Special-purpose tools Application
Grease MOLYKOTE PG-641
(CK-0562-000)
Applying to specified locations
Grease PERMALUBE G-2
(CK-0551-020)
Applying to specified locations
Cover switch tool
(QY9-0103-000)
Pressing the cover switch
To Next Page
Loading...
Need help?
General