Playback
•••••
--------------------------
SPECIAL
PLAYBACK
MODES
To
operate the special playback modes
use the buttons
on
the wireless controller.
There
is
no
sound during the special
playback modes.
To
return to normal
playback from the special playback
modes, press
lBffi.
•
Fast
Playback:
During normal playback
press
~/~.
Keep the button pressed
to rewind/fast forward the tape while
continuing the playback.
•
Reverse
Playback:
During normal
playback press
[-1
......
1.
•
Frame
Reverse/Advance:
During playback
pause press
[-I
......
I/I+I
..
~I.
Keep pressed
for continuous frame-by-frame playback.
•
Slow
Playback:
During normal or reverse
playback press I
SLOWI~
I.
•
Double
Speed
Playback:
During normal or
reverse playback press
@J.
CD
NOTES
•
You
can display the date and time
of
the
recording and other camcorder data registered
when the recording was made
(CD
51).
• During some special playback modes, you
may notice some video problems (blocky video
artifacts, banding, etc.)
in
the playback picture.
• During playback, you may notice some video
problems at the point where the standard
of
the
recording (HDV/DV) changes.
•
During
the
playback
of
HDV
recordings:
Even
though their icons will appear on screen, the
following special playback modes are not
available.
- Reverse slow playback
- Frame reverse
- Double speed playback (forward or reverse)
•
To
protect the tape and video heads, the
camcorder will enter the stop mode
(.)
if left
in
playback pause
(~II)
mode for 4 minutes 30
seconds.
To
resume the playback press
lBffi.
• Sound from the built-in speaker will
be
muted
while the STV-250N Stereo Video Cable is
connected to the camcorder.
Returning
to
a
Pre-marked
Position
If you wish to return to a particular scene
later, mark the point with the zero set
memory and the tape will stop at that
point when you rewind/fast forward the
tape.
(CD
10)
1 While recording or during playback,
press
[ZERO
SET
MEMORY]
on
the
wireless controller at the point you
wish to return to later.
• The time code changes to
"0:00:00I!I".
• Press
I~ZE-R-O-S-ET-M-E-M-O-R-,yl
again to
cancel the memory.
2 If you marked the zero memory
while recording, set the camcorder
to
liPLAY'(§211
mode. If you marked
the zero memory during playback,
press
~.
3 Press
~
to locate the zero mark.
• If the tape counter shows a negative _
number, press
~
instead.
• • appears and the camcorder
rewinds/fast forwards the tape.
• The tape stops at or near the zero
mark,
I!
disappears and the correct
time code will be displayed again.
If there are blank sections between recordings,
the zero set memory may not work correctly.
Locating
the
End
of
the
Last
Scene
After playing back a tape, use this
function to locate the end of the last
scene recorded
in
order to continue
recording form that point.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
