EN-12
• Unless otherwise specifically noted, all of the
procedures in this manual assume that the Digital
Piano is in its initial power on state (immediately after
you turn on power). If you run into problems with a
procedure, turn Digital Piano power off and back on,
and then try performing the procedure again.
• Note that turning off Digital Piano power during a
procedure causes any pending unsaved data to be
deleted.
The tones, rhythms, song bank songs, and music presets of
this Digital Piano are grouped into categories to make setting
option selection easier. When configuring settings, you can
first select a category and then select a setting option in that
category.
■ To navigate between categories
1.
Press 6 CATEGORY.
This causes one of the following mode indicators to flash
on the display: (tone), (rhythm), (song bank),
(music preset).
• Each press of 6 CATEGORY selects the next
sequential category.
• After pressing 6 CATEGORY, you can also scroll
forward and back between category names using the
bo dial.
• If you do not perform any operation for a while after
displaying a category, the display will automatically
exit the category screen.
2.
To exit the category screen, press
bp FUNCTION.
• For categories available in each mode, refer to the
Category column in the lists below.
– Tone list, rhythm list, song bank list, and music preset list
in the separate “Built-in Music Data Lists”
• To scroll forward or back from the current category to the
first item of previous or following categories (without
displaying the category names), hold down
6 CATEGORY as you rotate the bo dial.
Use the bo dial to change a number (tone number, etc.) or
value (tempo value, etc.), and to select menu items. You can
determine what operation you can perform with the bo dial by
checking the NUM indicator on the display.
■ To change a value or number (NUM indicator
displayed)
While the NUM indicator is displayed, the bo dial can be used
to change a number or value.
Example: Tone number selection screen
Example Operations
“To select an instrument for playing” (page EN-14)
“To adjust the tempo (beats per minute) value” (page EN-19)
• If a dial operation causes the value being changed to reach
its initial default (or recommended) value, the NUM
indicator will blink once to let you know.
Operations Common to All
Modes
Categories
Piano
Category number Category name
Dial Operations
Sta
g
e
Pno
To Next Page
Loading...
Need help?
General
Weight and Dimensions
