EN-21
Playing on the Keyboard
1.
Long-press bq TONE until an indicator mark
(
K
) appears next to “DUET” on the right side of
the display.
• This indicates the Duet Mode.
2.
Select a tone and perform the song you want.
• The left-side and right-side keyboard ranges are
assigned the same tone (Upper1 part tone).
3.
To exit the Duet Mode, long-press bq TONE
until the indicator mark (
K
) next to “DUET”
disappears.
• Each time you long-press bq TONE, the Digital Piano
will enter or exit the Duet Mode.
• Entering the Duet Mode automatically disables layer (page
EN-15) and split (page EN-16).
• You can configure the piano to output the left side keyboard
tone from the left speaker and the right side keyboard tone
from the right speaker while duet is turned on. Use the
operation under “Configuring Function Settings” (page
EN-45) to enable function number 6 (Duet Pan) in the
“Function Setting Item List” (page EN-46).
You can change the ranges of the left and right keyboards in
octave units from their initial default settings. This comes in
handy, for example, if the initial default range is not enough
when one person is playing the left hand part and another
person is playing the right hand part.
1.
Press bp FUNCTION.
2.
Use the bo dial to display the “Duet” setting
name, and then press bp ENTER.
3.
Use the bo dial to display “U Oct.” (right-side
keyboard) or “L Oct.” (left-side keyboard) and
then press bp ENTER.
This displays the NUM indicator.
4.
Use the bo dial to change the setting.
• You can specify the right-side keyboard octave while
“U Oct.” is displayed, and the left-side keyboard octave
while “L Oct.” is displayed.
• Increasing the setting value by one raises by one
octave, while lowering the value by one lowers by one
octave. The initial default for both settings is 0.
5.
Press bp ENTER to apply the displayed
setting.
This causes the NUM indicator to disappear.
6.
Repeat steps 3 through 5 of this procedure as
required to specify settings for both
keyboards.
Example
Specifying 0 for “U Oct.” and 1 for “L Oct.” results in the
keyboard octaves shown below.
7.
To exit the setting screen, press bq TONE.
• The octave settings you configure with the procedure
above are retained even when you exit the Duet Mode.
To play a duet
Changing the Octaves of the Duet Keyboards
UOct
.
Left keyboard Right keyboard
1 octave higher than initial setting Unchanged
To Next Page
Loading...
Need help?
General
Weight and Dimensions
