2-5
Since the calculation result uses a common denominator, calculation result still may
be displayed using the ' format even when coefficients (
a ´, c ´, d ´) are outside the
corresponding range of coefficients (
a , c , d ).
Example:
'
3
11
+
'
2
10
=
10
'
3 + 11
'
2
110
Calculation Examples
This calculation: Produces this type of display:
2 × (3 – 2 '5) = 6 – 4 '5 ' format
35 '2 × 3 = 148.492424 (=
105
'2)*
1
Decimal format
150
'
2
25
= 8.485281374*
1
23 × (5 – 2 '3) = 35.32566285 (=
115
– 46 '3)*
1
Decimal format
'2 + '3 + '8 = '3 + 3 '2 ' format
'
2 +
'
3 +
'
6
= 5.595754113*
2
Decimal format
*
1
Decimal format because values are outside of range.
*
2
Decimal format because calculation result has three terms.
• The calculation result is displayed using decimal format even if an intermediate result goes
greater than two terms.
Example: (1 + '2 + '3) (1 – '2 – '3) (= – 4 – 2 '6)
= –8.898979486
• If the calculation formula has a ' term and a term that cannot be displayed as a fraction,
the calculation result will be displayed in decimal format.
Example: log3 + '2 = 1.891334817
u Calculation Result Display Range with
A calculation results is displayed using π format in the following cases.
• When the calculation result can be displayed in the form
n π
n is an integer up to |10
6
|.
• When the calculation result can be displayed in the form
a
b
c
π or
b
c
π
However, {number of
a digits + number of b digits + number of c digits} must be 8 or less
when the above
a
b
c
or
b
c
is reduced.*
1
*
2
Also, the maximum number of allowable c digits is
three.*
2
*
1
When c < b , the number of a , b , and c digits are counted when the fraction is converted
from an improper fraction (
b
c
) to a mixed fraction (
a
b
c
).
*
2
When “Manual” is specified for the Setup screen “Simplify” setting, the calculation result
may be displayed in decimal format, even if these conditions are met.
To Next Page
Loading...
Need help?
General
