vii
u Entering the Examination Mode
1. Press !o(OFF) to turn off the calculator.
2. While holding down the c and h keys, press the o key.
• This displays the dialog box shown below.
3. Press 1(Yes).
• Read the message on the dialog box that appears.
4. Press 2.
• This displays the dialog box shown below.
5. Press J.
• Only the settings below are saved before entering the Examination Mode.
Input/Output, Frac Result, Angle, Complex Mode, Display, Q1Q3 Type, Language, Function
menu language, Battery Type
u Calculator Operation in the Examination Mode
• Entering the Examination Mode causes the entire display screen to be surrounded by a
green boundary. A flashing display icon ( ) will also appear on the display. The flash rate of
the icon slows down about 15 minutes after entering the Examination Mode.
Icon
Green boundary
• In the Examination Mode, the Auto Power Off trigger setting is fixed at approximately 60
minutes.
To Next Page
Loading...
Need help?
General
