α-11
When you see
this message:
It means this: So you need to do this:
First configure
animation
settings.
• You are trying to run an animation
without first configuring its settings.
• You are trying to execute an Add
Table command without first
configuring animation settings.
Configure animation settings and try
again.
Cannot Add
Animation
• The point you selected for an Add
Animation or Replace Animation
command operation cannot be used
in an animation because it is locked,
etc.
• The point you selected for an Add
Animation or Replace Animation
command operation cannot be used
in an animation because it is already
being used in the animation you are
configuring or in another animation.
Select a point to which animation can
be added and try again.
Select the
applicable
measurement
icon.
You are trying to execute the Add Table
command without first selecting the
appropriate measurement icon.
Select the icon of a measurement
that can be added to an animation
table.
First configure
animation
settings and
create a table.
You tried to execute the Display Table
command without generating an
animation table.
Generate an animation table first.
Create at least
one figure with
a fill color.
You are attempting to execute a surface
area calculation (K(Option) – 7:Area
Calc) when there is no figure on the
screen with a fill color.
Draw a figure with a fill color and try
again.
To Next Page
Loading...
Need help?
General
