44
(4)User disk clear
Press the Reset button for a period of one second or longer while the Fn key, CLR key, and the
period key are pressed.Full reset and similar warning screen appears.
Operation is also the same.Root disk (¥, ¥ Windows folder, etc.) and the registry, is initialized to the
factory default state.After formatting the FlashDisk, you can start it and then re-load the OS to RAM
do the reset process.
(Such as patch that is placed on a FlashDisk (CAB file) also disappears.)
(5)Power-on reset
This happens if there is no external power supply (AC) and the main battery are not in place, so the
unit has absolutely no battery power (discharged), and then a battery is fitted into the unit.
All RAM data storage memory (data and databases saved by the user, applications installed in
RAM, etc.), program execution memory used by the OS and applications, and memory used by
drivers are all “completely initialized” (clear). However, data on FlashDisk is retained.
RAM 4 minutes in a state of disconnect the battery, clock, 72 hours will be backed up.
(I call the state that holds only watch and RTC backup state).
2.8.4 Charge setting
A lithium ion rechargeable battery is being used at this end, but degradation is developed for
consumables.
When charging/discharging is repeated in particular, the battery capacity you can charge will fall
gradually.
Therefore the following 2 charge functions are offered according to the use conditions.
(1) usual charge
When connecting to a cradle or a charger, a charge is always begun.
(2) ecology charge
I make sure that the system will check a remaining amount of a battery and charge the occasion
with a lot of remaining amounts.
When assuming that this function was effective, the charge number of times can be reduced, and
it's possible to increase the cycle frequency life expectancy of the battery.
[Note] please refer to "3.1.8 Ecology charge setting" about a setting tool.
To Next Page
Loading...
Need help?
General