BASIC IMAGE RECORDING
E-52
— When recording portrait orientation images, position
the camera to it is standing up as straight as possible,
as shown in the illustration below. Holding the camera
at an angle can cause sensor errors. As a general
rule, do not allow the camera to be more than about 20
degrees off of vertical.
— Tilting the camera too far upwards or downwards can
also cause sensor errors. As a general rule, do not
allow the camera to point more than about 60 degrees
up or down.
CARD
— The camera orientation sensor does not work with
movie images.
Previewing the Last Image Recorded
Use the following procedure to preview the last image re-
corded, without leaving the REC mode.
1.
Press the PREVIEW button to display the last
image recorded.
• You can use the PREVIEW button in the Movie Mode,
too.
• The PREVIEW button does not perform any operation
if you press it immediately after turning on camera
power or immediately after entering to the REC mode
from the PLAY mode.
To Next Page
Loading...
Need help?
General
