BASIC IMAGE RECORDING
E-62
3.
Press SET/DISP to stop the indicator flash-
ing and fix the image focus at its current level.
• After stops flashing, you can use [왗] and [왘] to
adjust exposure compensation (EV).
• If stops flashing before you have a chance to fo-
cus, press / /MF RESIZE to make it flash again.
4.
Press the shutter release button to record the
image.
• The focus frame does not appear when you press the
shutter release button half way down while in the
Manual Focus Mode.
Using Focus Lock
Normally, Auto Focus automatically focuses on the object
that is inside the focus frame. Focus lock is a technique you
can use in the Auto Focus, Macro( ), and Infinity ( )
modes that lets you lock the focus on a subject and then
move the camera so the focus frame is pointed at another
subject when you record. This keeps the original subject in
focus, even though a different object is within the focus
frame.
NOTE
• Instead of using focus lock, you could also use the
procedure under “Specifying the Focus Frame Loca-
tion” on page E-63 to move the focus frame to a differ-
ent location.
1.
Align the POWER/Function Switch with REC.
2.
Align the focus frame with the subject you
want to lock on and press the shutter release
button half way down.
• The focus frame turns green when the image is in fo-
cus.
3.
While keeping the shutter release button de-
pressed half way, move the camera and com-
pose the image as you want.
Focus frame
To Next Page
Loading...
Need help?
General
