Cisco ASR-920-24TZ-M Installation Guide

4-10
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation Guide
Chapter 4 Initial Configuration
Safely Powering Off the Router
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the
system, extended setup will ask you to configure each interface on the system.
Basic management setup configures enough connectivity for managing the system; extended setup will
ask you to configure each interface on the system.
Checking the Running Configuration Settings
To check the value of the settings you have entered, enter the show running-config command at the
Router#
prompt:
Router# show running-config
To review the changes you have made to the configuration use the show startup-config command in the
user EXEC mode to see the changes and copy run-start stored in the NVRAM.
Saving the Running Configuration to NVRAM
To store the configuration or changes to your startup configuration in NVRAM, enter the copy
running-config startup-config command at the prompt:
Router# copy running-config startup-config
Using this command saves the configuration settings that you created in the router using the
configuration mode and the setup facility. If you fail to do this, your configuration will be lost, and will
not be available when you reload the router next.
Safely Powering Off the Router
This section explains how to shut down the Cisco ASR 920-24SZ-IM, ASR-920-24SZ-M,
ASR-920-24TZ-M Router. We recommend that before turning off all power to the chassis, you issue the
reload command. This ensures that the operating system cleans up all the file systems. After the reload
operation is complete, the Cisco ASR 920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Router can
be powered off safely.
To power off the Cisco ASR 920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Router safely,:
Step 1 Slip on the ESD-preventive wrist strap included in the accessory kit.
Step 2 Enter the reload command.
Step 3 Confirm the reload command.
Rmcp-6ru-1#reload
Proceed with reload? [confirm]
Aug 17 00:06:47.051 R0/0: %PMAN-5-EXITACTION: Process manager is exiting: prs exit with
reload chassis code

Cisco ASR-920-24TZ-M Specifications

General

Brand	Cisco
Model	ASR-920-24TZ-M
Category	Network Router
Language	English