Cisco ASR-920-24TZ-M Installation Guide

3-19
Cisco ASR-920-24SZ-IM, ASR-920-24SZ-M, ASR-920-24TZ-M Aggregation Services Router Hardware Installation Guide
Chapter 3 Installing
Installing and Removing the Interface Module
Installing the Interface Module
Note Before installing the interface module, read the Activating or Deactivating Interface Module section
in the Cisco ASR 920 Series Aggregation Services Router Configuration Guide.
Step 1 Before inserting an interface module, make sure that the chassis is grounded.
Step 2 If present, remove the blank filler plate covering the interface module slot. To remove, pull the blank
filler plate completely out of the router slot using the captive screws.
Step 3 To insert the interface module, carefully align the edges of the interface module between the upper and
lower edges of the interface module slot in the router.
Step 4 Carefully slide the interface module into the router slot until the interface module makes contact with
the backplane. Figure 3-14 shows how to install the interface module on Cisco ASR-920-24SZ-IM
Router.
Figure 3-14 Inserting an Interface Module on Cisco ASR-920-24SZ-IM Router
Step 5 Tighten the locking thumbscrews on both sides of the interface module. The recommended maximum
torque is 5.5 in.-lb (.62 N-m).

Cisco ASR-920-24TZ-M Specifications

General

Brand	Cisco
Model	ASR-920-24TZ-M
Category	Network Router
Language	English