Administration
LLDP Properties Configuration
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide 134
8
LLDP Properties Configuration
LLDP is a neighbor discovery protocol that is used for network devices to
advertise their information to other devices on the network. This protocol runs
over the data-link layer, which allows two systems running different network layer
protocols to learn about each other.
To enable LLPD properties on the router, follow these steps:
STEP 1 Select Administration >LLDP Properties.
STEP 2 Check Enable to enable the following: LLPD status, DSL_ATM_WAN_0_33_R,
ETH_WAN_R, DSL_PTM_WAN_1_1_R, IP_USB, PPP_USB.
STEP 3 Click Save.
Time Settings Configuration
You can configure your time zone, whether or not to adjust for Daylight Savings
Time, and with which Network Time Protocol (NTP) server to synchronize the date
and time. The router then gets its date and time information from the NTP server.
To configure NTP and time settings:
STEP 1 Select Administration > Time Settings. The current time is displayed.
STEP 2 Enter information in the following fields:
Time Zone Select your time zone, relative to Greenwich Mean
Time (GMT).
Adjust for Daylight
Savings Time
If supported for your region, check the Adjust for
Daylight Savings Time box.
Daylight Saving Mode If you select By date, enter the specific date when
daylight saving mode starts.
If you select Recurring, enter the month, week, the
day of the week, and time when daylight saving
time starts.
Enter the appropriate information in the From and
To fields.
To Next Page
Loading...
Need help?
General
