ComAp InteliDrive Lite User Manual

ID–Lite-2.0 User guide, ©ComAp – January 2011 30
ID-Lite-2.0 User guide.pdf
Getting started
How to install
General
To ensure proper function:
Wiring for binary inputs and analog inputs must not be run with power cables.
Analog and binary inputs should use shielded cables, especially when length >3m.
Power supply
To ensure proper function:
Use min. power supply cable of 1.5mm
2
Maximum continuous DC power supply voltage is 36VDC. Maximum allowable power supply voltage
is 39VDC. The ID-Lite’s power supply terminals are protected against large pulse power disturbances.
When there is a potential risk of the controller being subjected to conditions outside its capabilities, an
outside protection devise should be used.
Hint:
The InteliDrive-Lite controller should be grounded properly in order to protect against lighting strikes!!
The maximum allowable current through the controller’s negative terminal is 4A (this is dependent on
binary output load).
For the connections with 12VDC power supply, the InteliDrive-Lite includes internal capacitors that
allow the controller to continue operation during cranking if the battery voltage dip occurs. If the
voltage before dip is 12V, after 150ms the voltage recovers to 7 V, the controller continues operating.
During this voltage dip the controller screen backlight can turn off and on but the controller keeps
operating.
It is possible to further support the controller by connecting the external capacitor or I-LBA module.
Connecting the external capacitor Connecting I-LBA – Low Battery Adaptor module
+
-
12VDC
+
-
controller
T2A
Battery
+
D
C
Relays
+
-
12VDC
+
-
controller
T2A
Battery
Relays
I-LBA
+
-
+
-
The capacitor size depends on required time. It shall
be approximately thousands of microFarads.
The capacitor size should be
5 000 microFarad to withstand 150ms voltage dip
under following conditions:
Voltage before dip is 12V, after 150ms the voltage
recovers to min. allowed voltage, i.e. 8V
The I-LBA module ensures min. 350ms voltage dip
under following conditions:
RS232 and other plug-in module is connected.
Voltage before dip is 12V and after 350ms the
voltage recovers to min. allowed voltage 5V,
The I-LBA enables controller operation from 5VDC
(for 10 to 30 sec).
The wiring resistance from battery should be up to
0.1 Ohm for I-LBA proper function.

ComAp InteliDrive Lite Specifications

General

Brand	ComAp
Model	InteliDrive Lite
Category	Controller
Language	English