ID–Lite-2.0 User guide, ©ComAp – January 2011 38
ID-Lite-2.0 User guide.pdf
ECU-controlled engine support
One ID-Lite firmware branch covers both standard and electronic controlled (monitored) engines.
The appropriate engine/ECU type is selected in LiteEdit (3.0 or higher) like other peripheries. Press
the button in LiteEdit Configuration window.
Hint:
Import latest ECU list – ECU list-4.9.iwe for up to date engine ECU specification.
Select the proper esl file in LiteEdit-Options-ESL files – typically Allspeed.esl.
More information about ECU list packages, configuration and wiring recommendations can be found in
Comap Electronic Engines Support manual.
The ID-Lite controller always sends either speed request = 0 % or the IDLE command via J1939 in
controller IDLE state. In the MAN mode the IDLE operation can be controlled by Nominal/Idle binary
input.
Identifying configured ECU
Navigate to default screen with gauge and press buttons PAGE and ENTER at the same time. Then
browse through screen by button PAGE until you find value "ESF:xx.y - (zzz)", where xx.y = ESF
version number, zzz= Engine ID.
Engine ID index is in table below:
Engine ID
ESF - Electronic Engine
1 Volvo EMSI Singlespeed / EMSII
3 Scania S6 Singlespeed
4 Cummins CM570
5 Cummins MODBUS
7 John Deere
8 Deutz EMR2
9 DDC DDEC IV/V
10 Caterpillar J1939
12 Perkins ECM
14 Iveco NEF&Cursor
16 Scania S6 Singlespeed from ver.1794335
18 SISU EEM3 Gen-set
20 MTU ADEC J1939
25 Deutz EMR3
26 Cummins CM850
28 Iveco Vector
29 MAN MFR
31 VM Marine
32 VM Industrial
35 GM SECM
36 ISUZU ECM
44 E-control ECU
255 Standard J1939 engine
To Next Page
Loading...
Need help?
General
