ComAp InteliDrive Lite User Manual

ID–Lite-2.0 User guide, ©ComAp – January 2011 77
ID-Lite-2.0 User guide.pdf
How to change the display contrast?
Press ENTER and ↑ or ↓ at the same time to adjust the best display contrast
Hint:
Only in MEASUREMENT menu.
How to check the serial number and software revision?
Hold ENTER and then press PAGE. This activates the panel LED test. On the display you can see
(for 10 seconds) ID-Lite INFO screen containing:
1) Controller name (see Basic setting group)
2) ID-Lite serial number (8 character number)
3) SW version: the first is the firmware version number;
the second is configuration table number.
4) Application: DCU
5) Branch: Standard
Hint:
Only in MEASUREMENT menu.
How to change language?
Hold ENTER and then press PAGE to get to Serial number and software revision screen. Then press
PAGE to enter Language selection screen. Use ↑ or ↓ to select desired langue and press ENTER
to confirm selection.
How to find active alarms ?
Active alarm list is the last screen in the MEASUREMENT menu.
Select MEASUREMENT menu. Press ↑ You will see the list of all active alarms with the number of
alarms at the top-right corner three state alarms are introduced:
Description
* Wrn Water temp Active not accepted alarm
Wrn Water temp Active accepted alarm
* Wrn Water temp Inactive not accepted alarm
Inactive accepted alarm
Press FAULT RESET accepts all alarms. Non-active alarms immediately disappear from the list.
Active alarm list appears on the screen when a new alarm comes up and Main MEASUREMENT
screen is active.
Hint:
Alarm list does not activate when you are reviewing the values or setpoints.
Second alarm list for ECU alarms is also available. It is displayed one screen above the standard
alarm list on the controller display or under the standard alarm list in Control window of LiteEdit. If an
alarm appears in this alarm list, it is signalized in the standard alarm list and by exclamation mark on
the main measure screen.
Control from the front panel:
↑↓
One screen up/down
Enter Cursor move within the ECU alarm list
Enter + Fault reset ECU fault code reset
How to list History records ?
1. Use repeatedly PAGE button to select the History menu.
2. Use ↑ or ↓ to select requested History line – see Reason, Date and Time.
3. Press ENTER to go-on line to right – see recorded values.
4. Use repeatedly PAGE button to go back to Measurement screen.

ComAp InteliDrive Lite Specifications

General

Brand	ComAp
Model	InteliDrive Lite
Category	Controller
Language	English