108 BarometricPres 626 PrehActuator 970 AuxEngSdSwitch
110 EngCool Temp 628 EMSProgFailure 971 EngDerateSwtch
111 Coolant Level 629 Controller#1 1109 EngSdApproach
153 CrankcasePress 630 CalibrMemFail 1110 Engine Sd
Hint:
ID-Lite controller doesn’t support J1587 diagnostic line on Volvo engines. This can cause in some
cases a J1939 alarm message FC:000608 due to missing J1587 bus. Contact your Volvo distributor to
update ECU firmware.
For Scania Fault codes (FC) are displayed. Following messages are available for particular groups of
Fault codes:
Faultcode
Faultcode Diagnostic code
0x1000 Overspeed 0x6702 AlternatorChrg
0x1100 EngSpdSensor1 0x6A00 ExhaustBrkAct
0x1200 EngSpdSensor2 0xB000 OilPressProt
0x2000 WtrTempSensor 0xB100 CoolantLevProt
0x2100 ChrgAirTmpSens 0xB200 OverheatCoolWt
0x2200 ChrgAirPrsSens 0xB300 EmergencyStop
0x2300 OilTempSensor 0xB501 CoolantLevel
0x2400 OilPressSensor 0xC000 PDEInjctorCyl1
0x2600 SensorSupply1 0xC100 PDEInjctorCyl2
0x2700 SensorSupply2 0xC200 PDEInjctorCyl3
0x2800 ExtrAnalogInp 0xC300 PDEInjctorCyl4
0x3200 BatteryVoltage 0xC400 PDEInjctorCyl5
0x3300 CAN msg not ok 0xC500 PDEInjctorCyl6
0x3403 CAN version 0xC600 PDEInjctorCyl7
0x4300 HWWatchdog 0xC700 PDEInjctorCyl8
0x6200 FanActuator 0xE200 OverheatProt
0x6400 WasteGateAct 0xE600 CoordEmergStop
0x6600 StarterActuatr
Analog inputs
Reading of mentioned values from ECU enables to use analog inputs of the unit for other purposes,
e.g. measuring, displaying and alarm activation related to various quantities. The configuration thus
allows using three analog inputs on the central unit and four analog inputs on plug-in module if
connected.
If the engine without ECU is controlled by ID-Lite, the first analog input is permanently configured to
Oil pressure, other analog inputs remain freely configurable.
To Next Page
Loading...
Need help?
General
