ComAp InteliDrive Lite User Manual

ID–Lite-2.0 User guide, ©ComAp – January 2011 89
ID-Lite-2.0 User guide.pdf
InteliDrive-Lite LT works immediately after switch on at -30
o
C and display becomes visible after a few
minutes.
Dimensions and weight
Dimensions 180x120x55mm
Weight 450g
Binary inputs and outputs
Binary inputs
Number of inputs 6
Input resistance 4,2 kΩ
Input range 0-36 VDC
Switching voltage level for close contact indication 0-2 V
Max voltage level for open contact indication 8-36 V
Binary open collector outputs
Number of outputs 6
Maximum current 0,5 A
Maximum switching voltage 36 VDC
Analog inputs
Not electrically separated
Number of inputs 3
Resolution 10 bits
Jumper selectable range V, Ohm (default), mA
Maximal resistance range 2500 Ω
Maximal voltage range 2.5 V
Current range 0 – 20 mA
Input impedance 180 Ω for mA measuring
Input impedance > 100 kΩ for V measuring
Resistance measurement tolerance ± 2 % ± 2 Ω out of measured value
Speed pick-up input
Type of sensor magnetic pick-up (connection by shielded cable is
recommended)
Minimum input voltage 2 Vpk-pk (from 4 Hz to 4 kHz)
Maximum input voltage 50 Veff
Minimum measured frequency 4 Hz
Maximum measured frequency 10 kHz (min. input voltage 6Vpk-pk)
Frequency measurement tolerance 0,2 %
D+ function
Max. D+ output current 300 mA
Guaranteed level for signal Charging OK 80% of supply voltage
CAN bus interface
Galvanically separated
Maximal CAN bus length 200m
Speed 250kBd
Nominal impedance 120Ω
Cable type twisted pair (shielded)

ComAp InteliDrive Lite Specifications

General

Brand	ComAp
Model	InteliDrive Lite
Category	Controller
Language	English