ComAp InteliPro User Manual

InteliPro, SW version 1.4, ©ComAp – April 2014
InteliPro 1.4 Comprehensive Guide - rev. 1
3-12
IB-Lite
IB-Lite is a plug-in module with Ethernet 10/100 Mbit interface in RJ45 connector. The module is
internally connected to both COM1 and COM2 serial channels and provides an interface for
connecting a PC with LiteEdit or InteliMonitor through Ethernet/internet network, for sending active
e-mails and for integration of the controller into a building management (Modbus/TCP protocol).
IB-LITE MODULE
Use Ethernet UTP cable with RJ45 connector for connection of the module into your ethernet network.
The module can be also connected directly to a PC using cross-wired UTP cable.
CROSS-WIRED UTP CABLE
NOTE:
Please note that for correct operation of IB-Lite interface, the setpoint COM1 Mode must be set to the
DIRECT position!
For communication using Modbus TCP protocol via IB-Lite module, the recommended setting is:
COM1 Mode: DIRECT
COM2 Mode: MODBUS
ModbusComSpeed: 57600

ComAp InteliPro Specifications

General

Brand	ComAp
Model	InteliPro
Category	Relays
Language	English