xStack
®
DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
133
Layer 3 IP Networking
Static ARP Table
The Address Resolution Protocol (ARP) is a TCP/IP protocol that converts IP addresses into physical addresses. This table allows
network managers to view, define, modify and delete ARP information for specific devices.
Static entries can be defined in the ARP Table. When static entries are defined, a permanent entry is entered and is used to
translate IP addresses to MAC addresses.
To open the Static ARP Table click, Configuration > Layer 3 IP Networking > Static ARP Settings.
Figure 6- 115. Static ARP Settings window
To add a new entry, click the Add button, the following window will be displayed:
Figure 6- 116. Static ARP Table – Add a New Entry window
To modify an entry, click the Modify button, the following window will be displayed:
Figure 6- 117. Static ARP Table - Modify
The following fields can be set:
Parameter Description
IP Address
The IP address of the ARP entry.
MAC Address
The MAC address of the ARP entry.
After entering the IP Address and MAC Address of the Static ARP entry, click Apply to implement the new entry. To completely
clear the Static ARP Settings, click the Clear All button.
NOTE: The Switch supports up to 255 static ARP entries.
To Next Page
Loading...
Need help?
General