xStack
®
DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
194
Figure 7- 54. SNMP Host Table Configuration window
The following parameters can set:
Parameter Description
Host IP Address
Type the IP address of the remote management station that will serve as the SNMP host for the
Switch.
SNMP Version
V1 - To specifies that SNMP version 1 will be used.
V2 - To specify that SNMP version 2 will be used.
V3-NoAuth-NoPriv - To specify that the SNMP version 3 will be used, with a NoAuth-NoPriv
security level.
V3-Auth-NoPriv - To specify that the SNMP version 3 will be used, with an Auth-NoPriv security
level.
V3-Auth-Priv - To specify that the SNMP version 3 will be used, with an Auth-Priv security level.
Community
String/SNMP V3
User Name
Type in the community string or SNMP V3 user name as appropriate.
To implement your new settings, click Apply. To return to the SNMP Host Table, click the Show All SNMP Host Table Entries
link.
SNMP Engine ID
The Engine ID is a unique identifier used for SNMP V3 implementations. This is an alphanumeric string used to identify the
SNMP engine on the Switch.
To display the Switch's SNMP Engine ID, click Security Management > SNMP Manger > SNMP Engine ID. This will open
the SNMP Engine ID Configuration window, as shown below.
Figure 7- 55. SNMP Engine ID Configuration window
To change the Engine ID, type the new Engine ID in the space provided and click the Apply button.
SNMP Trap
The following window is used to enable or disable trap settings for the SNMP function on the Switch. To view this window for
configuration, click Security Management > SNMP Manger > SNMP Trap.
To Next Page
Loading...
Need help?
General