xStack
®
DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
31
Number
The "well-known" TCP port for the Web interface is 80.
Link Aggregation
Algorithm
The algorithm that the Switch uses to balance the load across the ports that make up the
port trunk group is defined by this definition. Choose MAC Source, MAC Destination, MAC
Src & Dest, IP Source, IP Destination or IP Src & Dest (See the Link Aggregation section of
this manual).
RMON Status
Remote monitoring (RMON) of the Switch is Enabled or Disabled here.
802.1x Status
MAC Address may enable by port or the Switch’s 802.1x function; the default is Disabled.
This field must be enabled to view and configure certain windows for 802.1x. More
information regarding 802.1x, its functions and implementation can be found later in this
section, under the Port Access Entity folder.
Port-Based 802.1x specifies that ports configured for 802.1x are initialized based on the port
number only and are subject to any authorization parameters configured.
MAC-based Authorization specifies that ports configured for 802.1x are initialized based on
the port number and the MAC address of the computer being authorized and are then
subject to any authorization parameters configured.
802.1x
Authentication
Protocol
The user may use the pull-down menu to choose between radius eap and radius pap for the
802.1x authentication protocol on the Switch. The default setting is radius eap.
Asymmetric VLAN
This field will enable or disable Asymmetric VLANs on the Switch. The default is Disabled.
Syslog Global State
Enables or disables Syslog State; default is Disabled.
Click Apply to implement changes made.
NOTE: When the Asymmetric VLAN function is Disabled, the user must change the VLAN setting
on the Switch to its default configurations.
To Next Page
Loading...
Need help?
General