56DSL-2750B User Guide
Once you enable Parental Controls, you can create ltering rules here.
Filtering Policy
Default Filtering Policy:
LAN Computer Policy:
Filtering Policy:
This is a global setting. If you select Block All, it will over-ride LAN Computer Policies and
Filtering Policies created and block all computers/devices from connecting to the Internet.
To use created policies, select Allow All.
This list will display any LAN computer policies. You can click the green + icon to add a new
entry, click the pencil icon to edit, or click the red X to delete the entry.
Click Add a LAN Computer to create a new entry (see below).
This list will display any lter policies that were created. You can click the green + icon to
add a new entry, click the pencil icon to edit, or click the red X to delete the entry.
Click Add a Policy to create a new entry (refer to the next page).
Add a LAN Computer
Enter the name or IP address (x.x.x.x) of your computer or device and then select Allow All, Block All, or any
created policy (see next page). You can then select a schedule from the drop-down. Click OK to continue.
WARNING: If you enter the computer you are working on and select Block All, you will disconnect from
the Gateway and will not be able to log back in (since you are blocked). You will have to connect to the
Gateway from another computer or reset the Gateway back to factory default settings.
To Next Page
Loading...
Need help?
General
