Danfoss vlt FC 102 Programming Guide

3.15.7 15-9* Parameter Info
15-92 Dened Parameters
Range: Function:
0* [0 - 9999 ] View a list of all dened parameters
in the frequency converter. The list
ends with 0.
15-93 Modied Parameters
Range: Function:
0* [0 - 9999 ] View a list of the parameters that
have been changed from their
default setting. The list ends with 0.
Changes may not be visible until
up to 30 s after implementation.
15-98 Drive Identication
Range: Function:
0* [0 - 40 ] This parameter contains data used
by the MCT 10 Set-up Software.
15-99 Parameter Metadata
Array [30]
Range: Function:
0* [0 - 9999 ] This parameter contains data used
by the MCT 10 Set-up Software
tool.
3.16 Parameters: 16-** Main Menu - Data
Readouts
3.16.1 16-0* General Status
16-00 Control Word
Range: Function:
0* [0 - 65535 ] View the control word sent from
the frequency converter via the
serial communication port in hex
code.
16-01 Reference [Unit]
Range: Function:
0 Referen-
ceFeedback
Unit*
[-999999 -
999999
Reference-
FeedbackUnit]
View the present reference value
applied on impulse or analog basis
in the unit resulting from the
conguration selected in
parameter 1-00 Conguration Mode
(Hz, Nm, or RPM).
16-02 Reference [%]
Range: Function:
0 %* [-200 -
200 %]
View the total reference. The total
reference is the sum of digital,
16-02 Reference [%]
Range: Function:
analog, preset, bus, and freeze
references, plus catch up and slow
down.
16-03 Status Word
Range: Function:
0* [0 - 65535 ] View the status word sent from the
frequency converter via the serial
communication port in hex code.
16-05 Main Actual Value [%]
Range: Function:
0 %* [-100 -
100 %]
View the 2-byte word sent with the
status word to the eldbus master
reporting the main actual value.
16-09 Custom Readout
Range: Function:
0 Custom-
ReadoutUni
t*
[-999999.99 -
999999.99
CustomRea-
doutUnit]
View the user-dened readouts as
dened in parameter 0-30 Custom
Readout Unit,
parameter 0-31 Custom Readout Min
Value, and parameter 0-32 Custom
Readout Max Value.
3.16.2 16-1* Motor Status
16-10 Power [kW]
Range: Function:
0 kW* [0 - 10000
kW]
Shows motor power in kW. The
value shown is calculated based on
the actual motor voltage and motor
current. The value is ltered, and
therefore approximately 1.3 s may
pass from when an input value
changes to when the data readout
values change. The resolution of
readout value on eldbus is in
10 W steps.
16-11 Power [hp]
Range: Function:
0 hp* [0 - 10000
hp]
View the motor power in hp. The
value shown is calculated based on
the actual motor voltage and motor
current. The value is ltered, and
therefore approximately 1.3 ms may
pass from when an input value
changes to when the data readout
values change.
Parameter Descriptions Programming Guide
M0010001 Danfoss A/S © 10/2019 All rights reserved. 163
3 3

Danfoss vlt FC 102 Specifications

General

Brand	Danfoss
Model	vlt FC 102
Category	DC Drives
Language	English