Danfoss vlt FC 102 Programming Guide

1 Introduction
VLT
®
HVAC Drive
FC 102 Series
This guide can be used with all
VLT
®
HVAC Drive frequency
converters with software version
5.x.
The actual software version
number can be read from
parameter 15-43 Software Version.
Table 1.1 Software Version
This publication contains information proprietary to
Danfoss. By accepting and using this manual, the user
agrees that the information contained in this is used solely
for operating equipment from Danfoss, or equipment from
other vendors if such equipment is intended for communi-
cation with Danfoss equipment over a serial
communication link. This publication is protected under
the Copyright laws of Denmark and most other countries.
Danfoss does not warrant that a software program
produced according to the guidelines provided in this
manual functions properly in every physical, hardware, or
software environment.
Although Danfoss has tested and reviewed the documen-
tation within this manual, Danfoss makes no warranty or
representation, neither expressed nor implied, concerning
this documentation, including its quality, performance, or
tness for a particular purpose.
In no event shall Danfoss be liable for direct, indirect,
special, incidental, or consequential damages arising out of
the use, or the inability to use information contained in
this manual, even if advised of the possibility of such
damages. In particular, Danfoss is not responsible for any
costs, including but not limited to those incurred as a
result of lost prots or revenue, loss or damage of
equipment, loss of computer programs, loss of data, the
costs to substitute these, or any claims by third parties.
Danfoss reserves the right to revise this publication at any
time and to make changes to its contents without prior
notice or any obligation to notify former or present users
of such revisions or changes.
The following symbols are used in this manual.
WARNING
Indicates a potentially hazardous situation which could
result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which could
result in minor or moderate injury. It may also be used
to alert against unsafe practices.
NOTICE
Indicates important information, including situations that
may result in damage to equipment or property.
Introduction
VLT
®
HVAC Drive FC 102
4 Danfoss A/S © 10/2019 All rights reserved. M0010001
11

Danfoss vlt FC 102 Specifications

General

Brand	Danfoss
Model	vlt FC 102
Category	DC Drives
Language	English