ENTER/EXIT PROGRAMMING MODE READING PARAMETERS
94
QUICKSCAN™ 2500
Stand Mode/Object Detection Illumination Off Time
Specifies the amount of time reader illumination stays off after pulling the trigger when
in Stand Mode/Object Detection. The configurable range is 01 to 32 by 01 in increments
of 500ms (500ms to 16 seconds).
Corded Stand Mode
This parameter sets the Stand Mode operation for corded models only.
Set Illumination OFF Time
$CSNTM
To configure, scan the ENTER/EXIT PROGRAMMING
MODE bar code above, then the bar code at left fol-
lowed by the digits from the Alphanumeric charac-
ters in Appendix D, Keypad representing your
desired character(s). End by scanning the ENTER/
EXIT bar code.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
04 = Illumination OFF Time 1 second
$CSMVS00
Corded Stand Mode = Disable
Corded Stand Mode = Generic Stand
$CSMVS01
$CSMVS02
Corded Stand Mode = Permanent Stand
Corded Stand Mode = Precise Stand
$CSMVS03
To Next Page
Loading...
Need help?
General
