To Next Page

To Previous Page

ENTER/EXIT PROGRAMMING MODE 1D SYMBOLOGIES

136

QUICKSCAN™ 2500

Code 39 Set Length 2

This feature specifies one of the bar code lengths for "Code 39 Length Control" on page

135

. Length 2 is the maximum label length if in Variable Length Mode, or the second

fixed length if in Fixed Length Mode. Length includes the bar code’s check, data, and

full-ASCII shift characters. The length does not include start/stop characters.

The length can be set from 1 to 50 characters. A setting of 00 specifies to ignore this

length (only one fixed length). See "

Set Length 2" on page 289 for more detailed pro-

gramming instructions.

Select Code 39 Set Length 2 Setting

$CC3L2

To configure this feature, scan the ENTER/EXIT PRO-

GRAMMING MODE bar code above, then the bar

code at left followed by the digits from the Alphanu-

meric characters in Appendix D, Keypad represent-

ing your desired character(s). End by scanning the

ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL



Length 2 = 50 (50 characters)

Datalogic QuickScan 2500 Series User Manual

Other manuals for Datalogic QuickScan 2500 Series