To Next Page

To Previous Page

CODE 39 ENTER/EXIT PROGRAMMING MODE

PRODUCT REFERENCE GUIDE

135

Code 39 Length Control

This feature specifies either variable length decoding or fixed length decoding for the

Code 39 symbology.

Variable Length: For variable-length decoding, a minimum length may be set.

Fixed Length: For fixed-length decoding, two different lengths may be set.

Code 39 Set Length 1

This feature specifies one of the bar code lengths for "Code 39 Length Control" on page

135

. Length 1 is the minimum label length if in Variable Length Mode, or the first fixed

length if in Fixed Length Mode. Length includes the bar code’s check, data, and full-ASCII

shift characters. The length does not include start/stop characters.

The length can be set from 0 to 50 characters. See "

Set Length 1" on page 288 for more

detailed programming instructions.

$CC3LC00



Code 39 Length Control

= Variable Length

Code 39 Length Control = Fixed Length

$CC3LC01

Select Code 39 Set Length 1 Setting

$CC3L1

To configure this feature, scan the ENTER/EXIT PRO-

GRAMMING MODE bar code above, then the bar

code at left followed by the digits from the Alphanu-

meric characters in Appendix D, Keypad represent-

ing your desired character(s). End by scanning the

ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL



Length 1 = 02 (2 characters)

Datalogic QuickScan 2500 Series User Manual

Other manuals for Datalogic QuickScan 2500 Series