AZTEC CODE ENTER/EXIT PROGRAMMING MODE
PRODUCT REFERENCE GUIDE
201
Aztec Code Set Length 1
Specifies one of the bar code lengths for "Aztec Code Length Control" on page 200.
Length 1 is the minimum label length if in Variable Length Mode, or the first fixed length
if in Fixed Length Mode. Characters can be set from 0001 to 3,832 characters in incre-
ments of 0001 (pad with zeroes).
See "
Set Length 1" on page 288 for detailed instructions on setting this feature.
Aztec Code Set Length 2
Specifies one of the bar code lengths for "Aztec Code Length Control" on page 200.
Length 2 is the minimum label length if in Variable Length Mode, or the first fixed length
if in Fixed Length Mode. Characters can be set from 0001 to 3,832 characters in incre-
ments of 0001 (pad with zeroes).
See "
Set Length 2" on page 289 for detailed instructions on setting this feature.
Select Aztec Code Length 1 Setting
$CAZL1
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
0001 = Length 1 is 1 Character
Select Aztec Code Length 2 Setting
$CAZL2
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar
code at left followed by the digits from the Alphanu-
meric characters in Appendix D, Keypad represent-
ing your desired character(s). End by scanning the
ENTER/EXIT bar code again.
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start
again at the beginning.
CANCEL
Length 2 is 3,832 Characters
To Next Page
Loading...
Need help?
General
