To Next Page

To Previous Page

ENTER/EXIT PROGRAMMING MODE 1D SYMBOLOGIES

176

QUICKSCAN™ 2500

ABC Codabar Dynamic Concatenation Timeout

This parameter specifies the timeout in 10-millisecond ticks used by the ABC Codabar

Dynamic Concatenation Mode. The timeout can be set within a range of 05 to 255 in

10ms increments. A setting of zero specifies no delay.

ABC Codabar Force Concatenation

When ABC Codabar Concatenation is enabled and Force Concatenation is disabled, both

Codabar stand alone labels and ABC Codabar concatenated labels are transmitted.

When ABC Codabar Concatenation is enabled and Force Concatenation is enabled only

ABC Codabar concatenated labels are transmitted while Codabar stand alone labels are

not transmitted.

Force Concatenation has no effect if the ABC Codabar Concatenation is disabled. The

Force Concatenation mode has effect both in Static and Dynamic Concatenation Modes.

Select ABC Codabar Dynamic Concatenation

Timeout Setting

$CCBDT

To configure this feature, scan the ENTER/EXIT PRO-

GRAMMING MODE bar code above, then the bar

code at left followed by the digits from the Alphanu-

meric characters in Appendix D, Keypad represent-

ing your desired character(s). End by scanning the

ENTER/EXIT bar code again.

Make a mistake? Scan the CANCEL bar code to abort

and not save the entry string. You can then start

again at the beginning.

CANCEL



Timeout = 20 (200 msec)

$CCBFC00



ABC Codabar Force Contatenation = Disable

ABC Codabar Force Concatenation = Enable

$CCBFC01

Datalogic QuickScan 2500 Series User Manual

Other manuals for Datalogic QuickScan 2500 Series