Steps
1. Align and place the smart card reader on the palm-rest and keyboard assembly.
2. Replace the two screws (M2x3) that secure the smart card reader to the palm-rest and keyboard assembly.
3. Adhere the smart card reader cable on the palm-rest and keyboard assembly.
4. Connect the smart card reader cable to the connector on the USH board.
Next steps
1. Install the assembly inner frame.
2. Install the battery.
3. Install the hard drive.
4. Install the WWAN card.
5. Install the wireless card.
6. Install the 2280 solid-state drive or 2230 solid-state drive.
7. Install the base cover.
8. Install the microSD card.
9. Install the SIM card.
10. Follow the procedure in After working inside your computer.
Coin-cell battery
Removing the coin-cell battery
Prerequisites
1. Follow the procedure in Before working inside your computer.
CAUTION:
Removing the coin-cell battery resets the BIOS setup program’s settings to default. It is
recommended that you note the BIOS setup program’s settings before removing the coin-cell battery.
2. Remove the SIM card.
3. Remove the microSD card.
4. Remove the base cover.
5. Remove the 2280 solid-state drive or 2230 solid-state drive.
6. Remove the battery.
7. Remove the hard drive.
8. Remove the wireless card.
9. Remove the WWAN card.
10. Remove the assembly inner frame.
About this task
The following image indicates the location of the coin-cell battery and provides a visual representation of the removal procedure.
80
Removing and installing components
To Next Page
Loading...
Need help?
General
