OPERATION
3-26 EPT031055 Issue 2 September 2017
Global Print Settings
Print Field Offset
Home > Settings > Global Print Settings > Print Field Offset
Offset for the print field in x and y direction in mm.
Note: The message must fit in the usable field, otherwise
“Transformation failed” error will occur.
Message Options
Home > Settings > Global Print Settings > Message Options
• Override global parameter sets with locals
• Use parameter sets which are defined within a message (local) or
system wide (global) parameter sets.
• To ensure that the correct parameter set is used if there are local and
global parameter sets with the same name.
• Load last message on startup
• Automatically loads the last live message on startup and enables
printing.
Marking Engine
Home > Settings > Global Print Settings > Marking Engine
Sets the Buffer Size (default value is 20).
At high printing speeds, with for example dynamic text objects such as
counters or dates/times, the time and computer performance may be
insufficient to recompile the new content to be printed. When using the
DSP-side Buffering, a buffer is filled whenever it is possible.
Setup Aiming
Home > Settings > Global Print Settings > Setup Aiming
The aiming beam may be used for installation to see where the objects of
the message are located on the product to print on.
Three options are implemented:
• Aiming beam disabled
• Aiming beam with laser power at the same time
• Aiming beam without laser power (aiming beam only).
To Next Page
Loading...
Need help?
General
