Domino F Series User Manual

INSTALLATION INSTRUCTIONS
EPT031055 Issue 2 September 2017 2-9
TOUCHPANEL
The installation must be carried out by trained technicians only.
Two supply voltages are provided for the TouchPanel which can be
operated individually or in parallel:
• Mains supply via the main socket. Only use the Domino power cord
VEY1414.
CAUTION: A free accessible power socket must be installed
nearby the TouchPanel. Extension cables must not
be used to connect the TouchPanel to mains power.
• The built-in power supply may be switched via the AC On/Off switch
on the TouchPanel.
• Power supply via the X59 ethernet connector of the BCP7 controller.
Only use the Domino X59 cables with 5m (Domino part number
L015211) or 10m (Domino part number L015212) length to connect the
TouchPanel to the BCP7 controller. Only these cables ensure the 24V
DC power supply of the TouchPanel. The power supply of the
TouchPanel fused with 2.5A inside the BCP7 controller. This power
supply may only switched off with the BCP7 controller On/Off
switch.
AC Mains supply via mains
socket
Power supply via BCP7
controller (X59)
AC On/Off
Switch

Domino F Series Specifications

General

Brand	Domino
Model	F Series
Category	Measuring Instruments
Language	English