INSTALLATION INSTRUCTIONS
EPT031055 Issue 2 September 2017 2-3
UNPACKING AND INVENTORY
Prior to and while unpacking the control unit and laser assembly, visually
check for damage that has occurred during transportation, in particular;
loose parts, dents, scratches and missing parts.
ASSEMBLY
Before assembly, check the laser head and control unit for visible damage.
Refer to PART 1: “HEALTH & SAFETY” .
The installation of the laser marking system has to comply to IEC 60825-1.
Environmental and Storage Conditions
The following conditions are necessary for operation and storage of the
laser marking system:
The controller is capable of operating within the International Protection
Code IP55, laser head IP65, which provides dust protection and protection
from splashing water. To protect the installation from more severe
conditions, extra measures must be taken.
Handling the Equipment
The equipment must be handled appropriately and carefully. The laser head
must not be held by the scanner head or by the supply lines. The control
unit is to be specifically protected during assembly.
CAUTION: The assembly, i.e. the mounting and the
installation of the laser marking system
must only be performed by personnel
qualified for this task and in accordance
with the valid regulations and safety
instructions.
Temperature +5°C to +35°C (optional up to 45°C)
90% max relative humidity - non-condensing
To Next Page
Loading...
Need help?
General
