OPERATION
3-28 EPT031055 Issue 2 September 2017
Content/Shift Codes
Home > Settings > Global Print Settings > Content
The Setup Shifts screen allows the start time of each shift and a shift code
to be set. Each shift continues until the start time of the next shift.
Click on +Add Row to add a new shift. Enter the start time and the shift
code. Delete a shift by using the delete button.
Clocks/Dates
Home > Settings > Global Print Settings > Clock/Dates
• Julian Leap Day
February 9th is marked as either 060 or 366 depending on the setting
for the Julian Leap Day.
•Expiration Update
Selects between midnight, after last shift and until first shift. After last
shift updates the clocks at the end of the last shift even if that shift
spans across midnight and into the next day. Until first shift updates
the clocks at the beginning of the first shift even if the first shift occurs
before midnight of the previous day.
•Week Begin Day
Selects a day of the week that is day 1 of each week.
• Time Granularity [ms]
Defines the time accuracy and time after which clocks are re-compiled.
Every clock is re-compiled after the time set here. Computing power
may be saved by setting a higher value for the granularity.
•Alpha Hours
Sets the string used by the Alpha Hour (h) time component.
•Defaults to A-Z (no I or O).
•Alpha Week Days
Sets the Alpha Day encoding string. Defaults to ABCDEFG.
• First letter corresponds to the “Week Begin Day”.
• Alpha Month Day
Sets the Alpha Month Day encoding string.
• Defaults to 1234567890ABCDEFGHJKLNPQRSTVXYZ.
First component corresponds to the “Week Begin Day”.
•Month Names
The Month Names can be edited in the Month Names dialogue box for
later inclusion in a message.
• Month Short Names
The Month Short Names can be edited in the Month Short Names
dialogue box for later inclusion in a message.
To Next Page
Loading...
Need help?
General
