Ecotech A Series User Manual

CHAPTER 4, DIGITAL COMMUNICATION
98307600 Rev. C-1 4-23
Command
RESET
Function
Reboots the instrument (software reset).
Format
RESET,{<DEVICE I.D.>}{TERMINATOR}
Device response
<ACK>
4.5 USB Communication
The USB port is located on the rear of the analyzer. This cannot be multidropped
with other analyzers, but multiple analyzers can be connected to a single USB port
on a computer by using a USB hub. This connection is ideal for collecting data
from a standalone analyzer or using a laptop that may not have a serial port.
4.5.1 Installing the driver on a PC
The following are instructions to install the EC9830 analyzer to a computer
through the USB connection. It will provide efficient communication between the
analyzer and computer with the use of the EC9800 Communicator software
described in section 4.6.
NOTE: screen shots and instructions below apply to
Windows XP, but will be similar for any other
Windows operating system.
1. Turn on computer and log in.
2. Connect the analyzer by USB cable to the USB port on the rear of the
computer.
3. After 10-20 seconds the dialog box shown in should appear. If no dialog box
appears, open the Control Panel and double-click Add New Hardware.

Ecotech A Series Specifications

General

Brand	Ecotech
Model	A Series
Category	Measuring Instruments
Language	English