Epson Aculaser C1700 Series User Manual

Problem Action
The output is wrinkled.
The output is stained.
Verify that the correct print media is being used.
If not, use the print media recommended for the printer.
If excessive wrinkles occur, use paper or other media from a new package.
See also:
❏ “Usable Print Media” on page 35
❏ “About Print Media” on page 33
If you use the envelope, check whether the crea se is with in 30 m m of t he fo ur edg es
of the envelope.
If the crease is within 30 mm of the four edges of the envelope, this is considered
normal. Your printer is not at fault.
If not, take the following actions:
❏ If the envelope is #10 envelope, which is 220 mm or longer and has a flap on the
long edge, use a different size envelope.
❏ If the envelope is C5, which is 220 mm or longer and has a flap on the short
edge, load it in the MPF with the flap open and facing up.
❏ If the envelope is Monarch or DL, which is shorter than 220 mm, load it long
edge feed in the MPF with the flap open and facing up.
If the problem continues, use a different size envelope.
Note:
If the problem continues even though you have taken suggested actions described above, contact the
Epson local representative office or an authorised dealer.
The Top Margin Is Incorrect
Problem Action
The top margin is incorrect. Ensure that the margins are set correctly on the application being used.
Epson AcuLaser C1700 Series User’s Guide
Troubleshooting 90

Epson Aculaser C1700 Series Specifications

General

Brand	Epson
Model	Aculaser C1700 Series
Category	Printer
Language	English