101
• Not connected to an extension cable
• Adjust the Noise Reduction setting in the projector's Picture menu.
• Select a computer video resolution and refresh rate that are compatible with the projector.
• If you adjusted the image shape using the projector controls, try decreasing the Sharpness setting in
the Picture menu to improve image quality.
• Make sure you selected the correct EDID setting in the projector's Picture menu.
• If you connected an extension power cable, try projecting without it to see if it caused interference in
the signal.
Parent topic: Solving Image or Sound Problems
Related references
Image Quality Settings - Picture Menu
Supported Video Display Formats
Solutions When the Image is Flipped or Too Small
If the projected image is flipped or too small, try the following solutions:
• If you flipped the projected image using the Reverse Flip Picture function, press the
Flexible Picture menu button on the remote control to display the Flexible Picture menu, and then
press the Flexible Picture menu button again to disable the function.
• If you adjusted the size of the projected image, press the Flexible Picture menu button on the
remote control to display the Flexible Picture menu, and then press the brightness up button until
the projected image is the right size.
• Make sure the projection orientation is correct in the projector's Settings menu.
Parent topic: Solving Image or Sound Problems
Solutions When the Image is Fuzzy or Blurry
If the projected image is fuzzy or blurry, try the following solutions:
• Adjust the image focus using the focus lever.
• Clean the projection window.
Note: To avoid condensation on the projection window after bringing the projector in from a cold
environment, let the projector warm up to room temperature before using it.
• Position the projector close enough to the screen.
To Next Page
Loading...
Need help?
General
