96
Status light Status and solution
Orange Projector has overheated and turned off. Leave it turned off to cool
down and wait about five minutes.
• Make sure that the vents and air filter are not clogged with dust or
obstructed by nearby objects.
• Make sure the environmental temperature is not too hot.
• Clean or replace the air filter.
• If operating the projector at high altitude, turn on High Altitude
Mode.
• If the problem persists, unplug the projector and contact Epson for
help.
Movement detection warning. A beep sounds and a warning message
is displayed. The brightness of the light source is reduced.
• Make sure that no one is looking into the projection window. Move
away from the projection window.
• Clean the motion sensor if there is no one near the projection
window.
Laser warning. Turn the projector off, unplug it, and contact Epson for
help.
Flashing orange Laser has a problem. Turn the projector off, unplug it, and contact
Epson for help.
A fan or sensor has a problem. Turn the projector off, unplug it, and
contact Epson for help.
Obstacle detection error. If there are no obstacles interfering with the
projection window, turn the projector off, unplug it, and contact Epson
for help.
Internal projector error. Turn the projector off, unplug it, and contact
Epson for help.
Parent topic: Solving Problems
Solving Image or Sound Problems
Check the solutions in these sections if you have any problems with projected images or sound.
To Next Page
Loading...
Need help?
General
