65
Muting the Sound Temporarily
You can temporarily mute the sound from your projection.
1. Press the mute button on the remote control to temporarily mute the audio.
The audio from the projection is interrupted.
2. To turn the audio back on, press the mute button again.
Parent topic: Adjusting Projector Features
Shutting Off the Picture Temporarily
You can temporarily turn off the projected picture if you want to redirect your audience's attention during
a presentation. Any sound or video action continues to run, however, so you cannot resume projection at
the point that you stopped it.
1. Press the blank button on the projector or remote control to temporarily stop projection.
The light source turns off and projection is interrupted.
2. To turn the picture back on, press the blank button again.
Parent topic: Adjusting Projector Features
Changing the Projected Image Using Flexible Picture
You can use the Flexible Picture features to change the projected image without moving the projector.
1. Turn on the projector and display an image.
2. Press the Flexible Picture menu button on the remote control.
Note: This button is not available when the Installation menu is displayed.
3. You can adjust the following settings:
• Use the brightness up or brightness down buttons on the remote control to adjust the image
size. You can reduce the image size to about 30%.
To Next Page
Loading...
Need help?
General
