J
Figure 3-5. Pica and Elite letters
30 LPRINT CHR$(27)"P";
40 LPRINT
PICA PITCH THE NORMAL PRINT
WIDTH"
When you RUN it, you should get:
Figure 3-6. Pitch comparison
The
10
blank spaces in line 20 above print as
10
Elite spaces; the
10
corresponding spaces in line 40 print as Pica spaces. This means, as
you can see in Figure 3-6, that the different width modes affect spaces
as well as characters. The modes also affect tabs, which we will discuss
in Chapter 9.
The ESCape “P" in line 30 turns Elite Mode off and returns the
printer to Pica pitch. Notice that, because Pica is the factory-set
default, it comes on whenever you turn the printer on (unless you’ve
changed the pitch default by changing a DIP switch).
Compressed Mode
To see a third handy print pitch that is available on FX printers,
replace your current program with this one:
53
To Next Page
Loading...
Need help?
General
