Description of the Individual Menu Items
If PERF. SKIP is set to YES the printer starts to print after the specified top
margin and stops printing before the bottom margin.
If PERF. SKIP is set to NO the printer ignores top and bottom margin and
prints from the very first to the very last line. That means that on a standard
12" paper 72 lines are available for printing.
(Cut Device is an option)
There are three settings possible for tear off and four settings for cut mode:
(only if Cut Device is activated)
When TEAR-OFF is selected the printer waits for one or ten seconds and,
unless further data are received, advances the paper to the first perforation
Regardless of this setting, whenever a change from fanfold to another paper
source occurs the printer will request the fanfold paper to be torn off before
the paper is moved into the park position. Furthermore, all settings can be
overruled by software (see command SPSIF).
means, that neither automatic feeding into the tear off
position no automatic cutting is performed. It is appropriate for batch output
causes the paper to move into the tear off
position if no new printing data have been received within 10 seconds. This
setting supports applications which do not close a print job by a form feed.
When the page is at the tear-off position and data transfer is continued
without having torn-off the page, the form is moved back so that printing can
resumed at the last print position. If the page has already been torn off
printing will be continued at the top of the next page.
To Next Page
Loading...
Need help?
General