Epson SC-F2000 User Manual

SC-F2000 Revision C
DISASSEMBLY & ASSEMBLY Overview 56
Confidential
3.1.4 Recommended Tools
To protect this product from damage, use the tools indicated in the following table. For
the tools required to perform the adjustment, refer to “Tools/Consumables for
Adjustments” in Chapter 4.
Table 3-1. Tools
Name Description Target Part
Phillips screwdriver, No. 1
4 cm or longer shaft length (The
one with a magnet is
recommended)
 PRINT HEAD
 Some encoders/sensors
Phillips screwdriver, No. 2
40 cm or longer shaft length (The
one with a magnet is
recommended)
Parts in general
Hexagon screwdriver
(5 mm)
Nothing in particular PG SWITCH LEVER ASSY
Stubby screwdriver Nothing in particular POWER SUPPLY BOARD
Tweezers Nothing in particular Parts in general
Acetate tape
To secure the cable/harness, or for
the protection against the sharp
edge
Parts in general (Use this tape
when it is removed or when
replacing the part)
Waste cloth
To prevent staining the printer
with ink during operation
 TUBE ASSY
 LEFT INK HOLDER
ASSY / RIGHT INK
HOLDER ASSY
 DUMPER KIT
 PRINT HEAD
 PUMP CAP ASSY
 BUFFR ASSY
 CIRCULATION PUMP
ASSY

Epson SC-F2000 Specifications

General

Brand	Epson
Model	SC-F2000
Category	Printer
Language	English