SC-F2000 Revision C
ADJUSTMENT TF Adjustments 251
Confidential
[Blue]: Button or menu name on the program screen / [Black]: Button or menu name on the operation panel of the printer
4.13 TF Adjustments
4.13.1 Pulley and TF Belt Position Adjustment
EXECUTION MODE
Normal Mode
STANDARD VALUE
4 to 5 mm
PROCEDURE
1. Disassemble the printer until you can access the TF belt.
2. Turn the printer ON.
3. Start the Service Program and select [Pulley and TF belt position Adjustment].
4. Click [RUN].
The TABLE ASSY moves back and forth three times, then stops in the rear
position.
5. Check the TF belt position, and if the gap on the left is within the standard, no
adjustment is necessary. Otherwise, perform the adjustment as follows.
Figure 4-52. TF belt position check
To Next Page
Loading...
Need help?
General